P2 Card Recording Time - Panasonic AJ-PX270 Operating Instructions Manual

P2 card access LED
Flashing green slowly
Off
* Mode check is displayed on the LCD monitor screen or the viewfinder screen. For details, refer to "Screen status display" (page 154).

P2 card recording time

r P2 cards supported on the camera
Optional P2 memory cards and microP2 memory cards with a capacity of 4 GB to 64 GB can be used with the camera.
@ NOTE
t AJ-P2C002SG (2 GB) cards cannot be used.
t When AVC-Intra 200 and AVC-Intra 100 in 1080/59.94P or 1080/50P mode is selected, you cannot record to the following P2 cards.
- P2 memory cards of R, A, or E series
t The driver installed on the camera may be required to be updated depending on the type of P2 card. (page 207)
t Refer to our support desk at the following website for the latest information not included in these operating instructions.
http://pro-av.panasonic.net/
r P2 card recording times
(Example when a 64 GB card is used)
System mode
1080P
1080i, 720P
480i, 576i
NOTE
@
t The above table shows values for regular recording. With native recording, even longer recording times are available depending on the system mode.
t In the case of 32 GB P2 cards, the recording time becomes 1/2 of the above recording times, in the case of 16 GB P2 cards, the recording time
becomes 1/4, and in the case of 8 GB P2 cards, the recording time becomes 1/8.
t Indicated capacities include management and other area, so the space available for recording is less than the values in the table above.
Chapter 3 Preparation — P2 card
There is no free space on the P2 card. Reading only is
Card full
possible.
The write-protect switch on the P2 card is at the Protect
Write protect
position. Reading only is possible.
Recording is not possible by the currently set recording
format since the SD memory card, etc. is inserted. To
Unrecordable card
record the card, change the recording format or use a
P2 card.
The card has been inserted into a different slot from the
Slot that is not recording
slot ([P2] or [microP2]) that was selected in the main
target
menu → [RECORDING SETUP] → [REC MEDIA].
This card cannot be used on the camera. Replace the
Card not supported
card.
The P2 card is not properly formatted. Reformat the
Illegal format
card.
The P2 card is not inserted. The card is waiting to be
No card
recognized.
This microP2 memory card cannot be authenticated.
Select the main menu → [CLIP] → [AUTHENTICATE],
Unauthenticated card and enter the password.
For details, refer to "Manual CPS authentication"
(page 122).
Recording format (codec)
AVC-Intra 200 30PN
AVC-Intra 200 25PN
AVC-Intra 100
AVC-LongG 25
AVC-LongG 12
AVC-Intra 200
AVC-Intra 100
AVC-Intra 50
AVC-LongG 50
AVC-LongG 25
AVC-LongG 12
DVCPRO HD
DVCPRO50
DVCPRO
DV
P2 card status
– 36 –
Mode check display*
[FULL]
[PROTECTED]
[REC IMPOSSIBLE]
[FULL]
[NOT SUPPORTED]
[FORMAT ERROR]
[NO CARD]
[AUTH NG]
Recording time
Approx. 32 min
Approx. 128 min
Approx. 240 min
Approx. 32 min
Approx. 64 min
Approx. 128 min
Approx. 128 min
Approx. 256 min
Approx. 480 min
Approx. 64 min
Approx. 128 min
Approx. 256 min
Approx. 256 min