Table of Contents
Advertisement
r Storage
Message
[CANNOT ACCESS CARD!]
[CANNOT ACCESS TARGET!]
[CANNOT COPY!][FORMAT
STORAGE DEVICE TO FAT]
[CANNOT FORMAT!]
[CANNOT RECOGNIZE
STORAGE DEVICE!]
[CANNOT SELECT!][MAX. 6
PARTITIONS]
[CARD IS EMPTY! CANNOT
COPY!]
[FORMAT P2 CARD!]
[LACK OF CAPACITY!]
[MISMATCH COMPONENT!]
[STORAGE DEVICE
DISCONNECTED!]
[TOO MANY PARTITIONS!]
[UNKNOWN DEVICE
CONNECTED!]
[VERIFICATION FAILED!]
Chapter 9 Maintenance — Warning system
Description
An error occurred while accessing the P2 card.
An error occurred while accessing the connection target.
The partition that can copy clips does not exist on the storage
device.
The storage device cannot be formatted.
The storage device is not correctly recognized.
Storage devices with more than 6 partitions cannot be
selected (mounted simultaneously).
The P2 card to copy is empty.
Cannot import to a P2 card containing clips.
Not enough space left on the storage device.
The P2 card model number of the copy source and copy
destination do not match. Cannot copy.
The connection with the storage device is disconnected.
There are too many partitions.
A non-compatible DVD drive or other device is connected.
The compare check performed after copying failed.
Check the P2 card.
Check the storage device status and connection.
Reformat in FAT format, or export the P2 card to create a
partition.
Change the connected storage device.
Reboot the storage device or connect another storage device.
Release selected partitions.
The copy operation is not performed because the card is
empty.
Format the P2 card.
Use a new storage device with sufficient available space or a
formatted storage device.
Use the P2 cards of the same model number, or import on a
clip basis.
Reconnect the USB cable to the <USB3.0> terminal (host).
When it does not function normally after that, turn off the
power once and turn on the power again.
The maximum number of partitions on the storage device is
23. Either reformat, or use a new storage device.
Change the connected device to the correct storage device,
and then turn the power off once and turn it on again.
Copy it again.
– 252 –
Measure
Advertisement
Table of Contents
