Push Buttons (Sw8-11); Board Reset Push Button (Sw12) - Analog Devices ADSP-21369 EZ-KIT Lite Manual

Push Buttons (SW8–11)
Four push buttons (
Two push buttons are connected to the
the other two are connected to the DAI of the processor. The push but-
tons are active high and, when pressed, send a high (
Refer to "LEDs and Push Buttons" on page 1-12
The push button enable switch (
buttons from the corresponding processor pins. Refer to
Enable Switch (SW7)" on page 2-13
The push buttons and corresponding processor signals are summarized in
Table 2-9.
Table 2-9. Push Button Connections
Push Button Label
PB1
PB2
PB3
PB4

Board Reset Push Button (SW12)

The push button (
RESET
exception is the USB interface chip (
push button is pressed after the USB cable has been plugged in and com-
munication initialized correctly with the PC. After USB communication
has been initialized, the only way to reset the USB is by powering down
the board.
ADSP-21369 EZ-KIT Lite Evaluation System Manual
www.BDTIC.com/ADI
ADSP-21369 EZ-KIT Lite Hardware Reference
) are provided for general-purpose user input.
SW8—11
) is capable of disconnecting the push
SW7
for more information.
Push Button Reference Designator
SW8
SW11
SW10
SW9
) resets all of the ICs on the board. The only
SW12
U4
pins of the processor, while
FLAG
) to the processor.
1
for more information.
"Push Button
). The chip is not reset when the
Processor Pin
FLAG1/~IRQ1
FLAG0/~IRQ0
DAI19
DAI20
2-17