Table of Contents
Advertisement
3.
On the next screen, indicate the number of battery sets connected to the UPS.
"Battery cabinet" here means "a set of 40 batteries" ("battery set", for short). A battery set may be
housed in one or more physical cabinets. So if you have two cabinets of 20 batteries each, choose "1"
on this screen. If you have four cabinets of 20 batteries each, choose "2".
Then press "Next".
4.
Indicate the capacity of the connected batteries in ampere/hours (Ah), then press "Next".
(This capacity figure is used by the UPS when in battery mode to calculate the amount of backup time
remaining.)
If you are not sure of your batteries' Ah capacity, look at one of the batteries in the battery cabinet(s).
The Ah rating is usually indicated on the battery's exterior. The Ah rating of a single battery is the
same as for the entire cabinet. Enter this number in the wizard screen.
Centric 3x480 Vac, Installation Guide, rel. 2.2
G
AMATRONIC
Figure 26: Initial config. wizard: number of battery sets
Figure 27: Initial config. wizard: battery capacity in Ah
E
I
L
LECTRONIC
NDUSTRIES
.
TD
33
Advertisement
Table of Contents
