Use Fixture In Stand-Alone Mode - ETC Source Four LED 3 Series User Manual

Use Fixture in Stand-alone Mode
After you connect power to the fixture, press the Function button (
to navigate to one of the following stand-alone modes, and then press the Intensity encoder to
select it:
Studio: Use one of three studio (white light) presets, or customize the presets.
•
Color: Use one of 12 color presets, or customize the presets.
•
Effects: Use a sequence, or customize a sequence.
•
Preset: Use one of 12 presets (color preset + fade time), or customize the presets.
•
The colors of options on the display correspond to the colors of the encoders below the display
and the Intensity encoder to the right of the display. Turn an encoder to modify the
corresponding value on the display, or press an encoder to activate the corresponding option at
the bottom of the display. Press the Intensity encoder to toggle between the current intensity
and 0%.
If the fixture is connected to other Source Four LED Series 3 fixtures that are in the same stand-
alone mode, the connected fixtures will play the same preset or effect.
Note:
navigate based on position rather than color:
Intensity = Intensity encoder
•
From top to bottom (in main section of display):
•
-
-
-
From left to right (at bottom of display):
•
-
-
-
16
If the colors on the display or on the encoders are difficult to discern, you can
Top value = Left encoder
Middle value = Center encoder
Bottom value = Right encoder
Left value = Left encoder
Center value = Center encoder
Right value = Right encoder
), use the Intensity encoder
Source Four LED Series 3 User Manual