Cancel Delay; Section 11. Heat Pump Setup; Solar Priority/Heat Pump Priority; Heat Pump (Heat Mode) - Jandy AquaLink Touch Owner's Manual

Wired/wireless controller
Hide thumbs Also See for AquaLink Touch:
Table of Contents

Advertisement

Page 44

10.23 Cancel Delay

This feature is for use by service personnel
NOTE
only.
MENU > SYSTEM SETUP > CANCEL DELAY
From the SYSTEM SETUP screen, touch the CANCEL
DELAY button.
System Setup
In-Floor
Chemlink
Disable
Clear
Memory
Cancel
Delay
Home
Menu OneTouch
Help
CANCEL DELAY should only be used by
NOTE
authorized service personnel. It should not be
used during normal system operation.
AquaLink
®
Touch™ Owner's Manual
Thu January 1, 2009 3:03 PM
Power
Back
Status
Photos

Section 11. Heat Pump Setup

11.1

Solar Priority/Heat Pump Priority

The SOLAR PRIORITY/HEAT PUMP menu allows the
system to use SOLAR HEAT/HEAT PUMP primarily.
If Solar Heat is no longer available, the system will
automatically switch to the alternate heat source.
MENU > SYSTEM SETUP > SOLAR PRIORITY
From the SYSTEM SETUP screen, touch the SOLAR
PRIORITY button to enable the solar priority feature.
System Setup
Heat
Assign
Pump
JVAs
HP Priority
Dusk
N/A
Setup
All Off
Slr Priority
Time
Disabled
Home
Menu OneTouch
Help
When solar and heater are enabled the solar will heat
the water until either the thermostat setting has been
reached or solar heat is no longer available. If the solar
panel is not hot enough, solar heat will shut off and the
other heat source (usually gas heater) will take over to
bring the water up to the thermostat setting. This menu
is used to ENABLE or DISABLE the solar priority.
Depending on the position of DIP switch S2-1
NOTE
and the presence of a solar or heat pump
sensor, SOLAR PRIORITY or HEAT PUMP
PRIORITY may be displayed on the SYSTEM
SETUP menu. It is not possible to have both
SOLAR PRIORITY and HEAT PUMP PRIORITY
displayed on SYSTEM SETUP MENU at the
same time. It is one or the other.
11.2

Heat Pump (Heat Mode)

This equipment may not be part of your system.
NOTE
Please check with your installer.
The HEAT MODE selection controls the heat pump
operation.
Thu January 1, 2009 3:03 PM
PLockOut
Air Temp
Enabled
Enabled
DST
Temp
Enabled
Calibrate
Product
Degrees
Info
Back
Status
Photos
Power

Advertisement

Table of Contents
loading

Table of Contents