Table of Contents
Advertisement
Page 30
When a pool or spa light is turned ON manually,
NOTE
by the OneTouch control panel, or by a
program, the last used color will automatically
be chosen unless you press SELECT to change
the color.
If you press the BACK key when in the
EQUIPMENT ON/OFF menu, the light will turn
on the last selected color. If the SELECT key or
the BACK key is not pressed, and if it has been
15 seconds since the UP/DOWN keys have
been pressed, then the most recently selected
color will be selected again.
9.9
TEMP1 / TEMP2 (Pool or Spa Only)
TEMP1 is the priority temperature. It must be set higher
than TEMP2, and it overrides TEMP2 whenever it is
enabled. Set temperature for TEMP1 before setting
temperature for TEMP2.
9.9.1
To Set Up TEMP1
The valid temperature setpoint range is
NOTE
between 34° - 104° F. If you enter a value
outside this range, an invalid entry message will
appear on screen.
HOME > OTHER DEVICES ON / OFF > DEVICES > TEMP1
From the HOME menu screen, touch the OTHER
DEVICES ON/OFF button to display the DEVICES
screen.
From the DEVICES screen, touch the TEMP1 button to
display the SET TEMPERATURE.
Devices
Filter
On
Sprinklers
Pump
Variable
Adj
Aux 1
Speed
ENA
Temp1
Aux 2
Off
Temp2
Aux 3
Solar Heat
Pool Light
Off
Home
Menu OneTouch
Help
Set the desired temperature on the numeric keypad as
follows:
▪ Enter the desired water temperature.
▪ Touch ENTER when fi nished to make new temperature
to take effect.
AquaLink
®
Touch™ Owner's Manual
Thu January 1, 2009 3:03 PM
Off
Aux 5
Off
On
Off
Aux 6
On
Off
Aux 7
Page
Off
Off
All Off
All Off
Off
Back
Status
Photos
Power
Set Temperature
Temp 1
80º
Home
Menu OneTouch
Help
9.9.2
To Set Up TEMP2 (For Pool and
Spa Only System)
The TEMP2 is the maintenance (low) temperature.
It must be set lower than TEMP1. If TEMP2 is on
and TEMP1 is activated, TEMP2 will turn off. When
TEMP1 is turn off again, TEMP2 will reactivate.
The valid temperature setpoint range is
NOTE
between 34° - 104° F. If you enter a value
outside this range, an invalid entry message will
appear on screen.
HOME > OTHER DEVICES ON / OFF > DEVICES > TEMP2
From the HOME menu screen, touch the OTHER
DEVICES ON/OFF button to display the DEVICES
screen. From the DEVICES screen, touch the TEMP2
button to display the SET TEMPERATURE screen.
Set the desired temperature on the numeric keypad as
follows:
▪ Enter the desired water temperature.
▪ Touch ENTER when fi nished to make new temperature
to take effect.
Set Temperature
Temp 2
75º
Home
Menu OneTouch
Help
Thu January 1, 2009 3:03 PM
Set To:
90
7
8
9
4
5
6
1
2
3
0
Clear
Enter
Back
Status
Photos
Power
Thu January 1, 2009 3:03 PM
Set To:
75
7
8
9
4
5
6
1
2
3
0
Clear
Enter
Photos
Power
Back
Status
Advertisement
Table of Contents
