Location Requirements For Pool And Spa Light Applications; Section 3. Installation; Mounting - Jandy Infinite WaterColors IWCP50W100 Installation And Operation Manual

Jandy Infinite WaterColors LED Light Controller
® ™
Figure 1. Package Contents
2.2 Location Requirements for
Pool and Spa Light Applications
In order to protect the Infinite Water Colors LED Light
Controller from pressurized water spray (such as that
from irrigation sprinklers) and from mechanical impacts
and/or damage, it should be located:
• At least 4 inches (10 cm) above the ground.
• At least 8 inches (20 cm) above the water level.
• At least 4 feet (1.3 m) from the inside edge of the
pool or spa, at least 10 feet (3 m) from a fountain, or
as required by local code in the US.
• At least 10 feet (3 m) from the inside edge of the
pool, spa or fountain in Canada, or as required by
local code.

Section 3. Installation

3.1

Mounting

The Infinite WaterColors LED Light Controller is shipped
with mounting brackets fastened on the back.
• Turn the Light Controller over and inspect the
brackets installed inverted on the back.
• If any parts are missing or damaged, please call
your local distributor or technical support at
1-800-822-7933 for assistance.
1. Remove mounting screws from upper and lower
brackets on the back of the Light Controller.
2. Rotate and secure upper and lower brackets with
mounting screws to the same mounting holes,
see Figure 2.
|
Installation & Operation Manual
1
2
3
4
Figure 2. Install Brackets
3. Mark the location for the mounting screws.
4. Drill holes where the mounting screws will be
installed.
5. Secure screws (or other hardware appropriate
for the mounting surface) through either the
keyhole slots or the mounting holes of the Light
Controller enclosure, see Figure 3.
Figure 3. Mounting Light Controller
ENGLISH
Page 5