Table of Contents
Advertisement
USE AND MAINTENANCE MANUAL
Emergency manual procedures
If the machine is blocked due to mechanical or electrical fault, or due to the operator's fault, it is possible
to put it into the transport configuration which can be facilitated by the operator from the ground.
In the standard configuration of the machine, the emergency procedure consists in using the electric
valves of the hydraulic blocks located on the machine and the movements are performed using the
manual pump located to the side of the tank.
If the optional 12 V electric pump is installed on the machine, the movements are performed electrically.
There are two emergency procedures requiring the use of electric 12 V pump depending on the problem
to be addressed:
•
The machine is blocked and no alert is signalled (e.g. no fuel)
•
The machine is blocked with the alert activated
The procedure to follow when the machine is blocked with an alert is the same used for the standard
configuration with a manual pump.
The 12V electric pump is connected to the starter battery and its prolonged use will cause
Any manually executed procedures may cause the machine to overturn,
Before carrying out any emergency operations, press down the red emergency stop
Before carrying out any emergency operations, make sure there are no obstacles of any
it to discharge quickly
so make sure you always perform them very carefully
kind around the machine
button
89
IM R13 T
Advertisement
Table of Contents
