Table of Contents
Advertisement
USE AND MAINTENANCE MANUAL
Automatic stabilisation (optional)
M2 M3
When the pictogram
out is completed and the operation is automatically stopped.
•
Reset the selector into a neutral position.
•
When another operation has raised the chassis out of the ground, another automatic stabilisation
operation should be carried out.
•
Always check visually the effective levelling out of the machine by making use of the special spirit
level.
With the cage in its stowed away seat:
•
If the machine is inclined above 1°, the pictogram
of levelling.
•
If one or more stabiliser feet should lose touch with the ground, the pictogram will appear on the
display unit and all the movements of the aerial part will be blocked.
The stabilisation operation should be repeated in every one of the above referenced cases.
With the aerial part of the machine open
•
If the machine is inclined above 1° the pictogram
hazard of overturning.
•
If one of the stabiliser feet should lose touch with the ground, the pictogram
on the display unit, whereas all the movements of the aerial part will remain
In none of the above referenced cases the electronic system of the machine will block any operations.
It is the operator's prerogative to decide whether to continue operating the machine, or to close down
the aerial part of the machine and have it reset in a stabilised mode.
•
If two stabiliser feet should lose touch with the ground, the pictogram
display unit and all the movements of the aerial part will be blocked, except for the following ones:
•
Retraction of the extension
•
Lowering of the jib
Turn S5 backward and keep it pressed for the duration of
the operation; the stabilisers are lowered down and the
machine is now stabilised and levelled out.
M4 M5
appears on the display unit on the platform control panel, the levelling
on the display unit will signal the loss
:
on the display unit will signal the imminent
80
IM R13 T
will appear
active.
will appear on the
Advertisement
Table of Contents
