Table of Contents
Advertisement
USE AND MAINTENANCE MANUAL
Platform panel battery for radio control
The battery inserted into the lower part of the platform panel, allows for the use by radio. Another battery
is supplied to be always placed in the battery charger.
The replacement is quick and very simple to perform.. The operation of a fully charged battery is about
8 hours.
must be changed. If the capacity of the battery is too low, the platform panel may not turn on.
The battery capacity and operational performance are reduced in conditions of extreme cold. The battery
recharges automatically during the use of the platform panel with the serial cable.
In order to minimize the consumption of the battery, and, for safety reasons, the platform panel turns off
automatically after a period of inactivity of 30 minutes.
Battery charger
Battery charger is placed in a box of the left-hand side of the turret.
It is supplied from a 12 V battery for the motor start-up and it is designed to prevent damage to the battery
even if it is subjected to the long cycles of continuous charging.
There are two LED indicators on the upper part of battery charger:
• Red LED (power) - Indicates the presence of the supply voltage.
• Green LED (status of charge)
• Flashing, the battery is charging (the battery charger is in fast charge mode)
• Lit up steady, the battery is charging (the battery charger is in charge maintenance mode).
When the battery is low, the platform panel beeps three times as a
warning and the red LED ON begins to flash (led on the left of the
emergency stop button). When a battery is fully charged the red LED
ON is activated.
The battery must be used until the red LED turns off, after which it
28
IM R13 T
Advertisement
Table of Contents
