Table of Contents
Advertisement
12
Push the seal (apply a thin coat of
vacuum grease on two types of O-ring) on
the top end of the seal tube head by fingers.
(out of two grooves provided on the outer
periphery of the seal, the upper one is not for
O-ring but for introducing the top end of the
seal extractor when removing the seal.)
The top end of the seal is an important
section which prevents the liquid from
leaking. If this end is damaged, a defect
such as a leakage of liquid will occur.
Take great care when handling this
section.
13
Connect tubes to the seal body assembly
to make it ready for mounting.
Water connector
Seal
body
assembly
Outlet line
-19-
Installing
O-rings on Seal
Lubricating unit
Connect to
WATER IN
Screw socket (B)
Screw
socket (A)
Pressure
gage
Outlet line
Pump
Tube
Tee
Advertisement
Table of Contents
