Table of Contents
Advertisement
6
Connect the cooling water tube, oil circulation
tube and waste oil (drain) to the bearing housing.
Refer to the figure below for connections.
a. Connect to OIL IN
b. Connect to
DRAIN IN
c. Connect to WATER OUT
7
Put the bearing housing gently on the rotor shaft
until the bottom surface of the bearing housing
touches the door adapter. Then turn about 60°to
engage the stopper with the door adapter in such
manner that the water passage faces the rear of the
centrifuge.
8
Position the bearing housing stopper (B) which
prevents the bearing housing from turning in the
gap between the bearing housing and door adapter.
e. Hole for water passage
d. Connect to OIL OUT
-17-
Water
passage
Centrifuge front
Stopper (B)
Advertisement
Table of Contents
