Starting The Engine - HERO SPLENDOR+ PROGRAMMED FI Manual

STARTING THE ENGINE

Always follow the proper starting procedure
described below:
To protect the catalytic converter in your
•
vehicle's exhaust system, avoid extended
idling and the use of leaded petrol.
Your vehicle's exhaust contains poisonous
•
carbon monoxide gas. High levels of carbon
monoxide can collect rapidly in enclosed
areas such as garage. Do not run the engine
with the garage door closed.
CAUTION
! !
If electric starter switch is pressed
•
continuously and engine does not start,
cranking of engine will stop after 5 secs.
After that rider again needs to press the
electric starter switch.
If engine started, cranking of the engine will
•
stop after r/min reaches more than 1000.
Preparation
Before starting insert the key and follow the
below mentioned procedure:
Turn the ignition key (1) to "ON" ( )
•
position.
Confirm that the programmed FI
•
malfunction indicator lamp (MIL) (2)
glows continuously and then should go
"OFF" once the engine is started.
1
(1) Ignition key
malfunction indicator lamp (MIL)
If MIL remains "ON" even if the vehicle is
started, there is an abnormality in the
programmed FI system. It is recommended to
reduce the speed and drive to the Authorised
workshop for check-up
Hero MotoCorp
(3) Neutral indicator
21
2
(2) Programmed FI
NOTE
3