Electrical Data - Edwards E1M18 Instruction Manual

E2M18
* To operate the pump when the ambient temperature is outside the range specified in
Operating and storage conditions on page 13
processing condensible vapours, a different oil may be required.

3.5 Electrical data

Refer to
single-phase motors on page
motor rating plate. The motor start-up current is drawn for less than one second, so
time-lag fuses must be used to prevent unnecessary fuse failure when the pump starts.
Fuses should be to EN60269
lower than 13 °C, the start-up current will be drawn for longer; this may cause the motor
thermal overload device to open.
Table 5 Electrical data: three-phase motors
Pump item
Voltage (V)
number
A34310940 200 - 220
380 - 415
200 - 230
460
A36310940 200 - 220
380 - 415
200 - 230
460
Motor output rating (continuous)
50 Hz operation
60 Hz operation
Table 6 Electrical data: single-phase motors
Pump item number
A36315903, A34316903,
A34315903
A34315981, A36315981
A34315904, A36315904
A34310880_T - Technical data
Table: Electrical data: three-phase motors on page 17
17. For motor current information please refer to the
Performance on page
Frequency
(Hz)
50
50
60
60
50
50
60
60
0.65 kW
0.75 kW
Voltage
(V)
220 - 240
230 - 240
115
230
100
100 - 105
200
200 - 210
or to optimise pump performance when
13. If using the pump at temperatures
Full load
current
(A)
3.3
1.9
2.3
1.6
3.3
1.9
3.4
1.6
Frequency
(Hz)
50
60
60
60
50
60
50
60
Page 17
1.05 litres
and Table: Electrical data:
Recommended supply
protection (A)
10
6
10
6
10
6
10
6
Full load current (A)
4.6
5.0
11.0
5.5
12.0
11.0
6.0
5.5