Electrical Installation: Three-Phase Motors; Connect The Electrical Supply To The Motor; Figure 8: Motor Voltage Selection: Single-Phase Motors, 110/200-240 V 50 Hz And 115-120/200-240 V 60 Hz - Edwards E1M18 Instruction Manual

Figure 8 Motor voltage selection: single-phase motors, 110/200-240 V 50 Hz and
115-120/200-240 V 60 Hz
A
3
A. Top view of motor A. Top view of motor
C. On/Off switch C. On/Off switch
1. Terminal box cover 1. Terminal box cover
3. On/Off switch 3. On/Off switch
5. Position 'O' (off) 5. Position 'O' (off)
7. Position 'II' (high voltage setting 7. Position 'II' (high voltage setting
200‑240 V) 200‑240 V)

4.7 Electrical installation: three-phase motors

4.7.1 Connect the electrical supply to the motor

WARNING:
Ensure that the electrical installation of your pump‑motor conforms with your local
and national safety requirements. It must be connected to a suitably fused and
protected electrical supply and a suitable earth point.
CAUTION:
If your pump‑motor can be used with more than one voltage range, you must ensure
that the motor is configured for your electrical supply voltage. If you do not, you may
damage the motor.
Note:
The pump will restart automatically when the electrical supply is restored after an
interruption. If you do not want the pump to restart automatically, use electrical control
equipment which must be reset manually.
A34310880_T - Installation
1
2
4
5
Page 26
B
6
7
B. Internal view of top of motor B. Internal view of top of motor
2. Electrical inlet socket 2. Electrical inlet socket
4. Position 'I' (on) 4. Position 'I' (on)
6. Voltage selector switch 6. Voltage selector switch
8. Position 'I' (low voltage setting 8. Position 'I' (low voltage setting
110‑120 V) 110‑120 V)
8