Status Info Menu - Det-Tronics X9800 Addendum

STATUS INFO MENU

This menu (read-only) shows extensive status information about the detector.
X9800 Root Menu
1) Fire (Yes/No)
2) Fault (Yes/No)
3) Device Info Menu
4) Command Menu
5) Device Setup Menu
1) Warm Up (Y/N)
2) Fire (Y/N)
3) IR Alarm (Y/N)
4) TDSA Alarm (Y/N)
5) Quick Alarm (Y/N)
6) IR Pre Alarm (Y/N)
7) Auto IR o i Flt (Y/N)
8) Manual o i at Start (Y/N)
9) Sensor Hdwr. Flt (Y/N)
10) HIB Hardware Flt (Y/N) HART Interface Board hardware fault.
11) Internal Com. Flt (Y/N) Internal communication fault.
12) Incompatible Flt (Y/N) Sensor module firmware version is not compatible with HART Interface
13) Voltage Fault (Y/N)
14) Hardware Menu
15) o i Menu
2.2
Device Info Menu
1) General Info Menu
2) HART Info Menu
3) Status Info Menu
4) Detector Settings
5) History Menu
Device is in the power-up time delay (warm-up) mode.
Indicates "Y" if the device is in a fire alarm status — analog output is at 20 mA,
fire alarm relay is actuated, and LED is red.
Indicates "Y" if the IR detector is signaling an alarm.
Indicates "Y" if the IR detector is signaling a TDSA alarm.
Indicates "Y" if the IR detector is signaling a quick alarm.
Indicates "Y" if the IR detector is in a pre-alarm state. .
Automatic IR o i Fault. Check viewing window and o i reflector plate for cleanliness.
Manual o i at start. On power-up a manual o i was started. Check the external
input wiring.
Sensor hardware fault.
Board.
Detector operating voltage is out of tolerance.
Refer to sub-menu.
Refer to sub-menu.
Status Info Menu
1) Warm Up (Y/N)
2) Fire (Y/N)
3) IR Alarm (Y/N)
4) TDSA Alarm (Y/N)
5) Quick Alarm (Y/N)
6) IR Pre Alarm (Y/N)
7) Auto IR Oi Fault (Y/N)
8) Manual Oi at Start
9) Sensor Hdwr. Fault (Y/N)
10) HIB Hardware Fault (Y/N)
11) Internal Com. Flt (Y/N)
12) Incompatible Fault (Y/N)
13) Voltage Fault (Y/N)
14) Hardware Menu
15) Oi Menu
10
95-8637