Command Menu - Det-Tronics X9800 Addendum

COMMAND MENU

The Command Menu allows the operator to initiate a manual o i test and also to perform various reset/
clear functions.
X9800 Root Menu
1) Fire (Yes/No)
2) Fault (Yes/No)
3) Device Info Menu
4) Command Menu
5) Device Setup Menu
1) Start Passive o i
2) Start Active o i
3) Clear o i Fault
4) Reset Latches
5) Master Reset
6) Clear Data Log
7) HART Command Menu
2.2
Command Menu
1) Start Passive Oi
2) Start Active Oi
3) Clear Oi Fault
4) Reset Latches
5) Master Reset
6) Clear Data Log
7) HART Command Menu
A passive o i test command checks the cleanliness of the detector's
optical surfaces. This calibrated o i test confirms the ability of the detector
to respond correctly to an IR signal. Fire and fault relays as well as
0–20 mA current loop output are unaffected by this test. A red LED signals
a successful test, and an amber LED signals a failed test. The general log
will indicate either "Man o i Pass" or "Man o i Flt."
An active o i test generates an actual Fire Alarm Output. All fire
response equipment must be bypassed/disabled prior to testing to
prevent unwanted output actuation.
An active o i test performs an o i test with all detector outputs fully
operational. Fire and fault relays as well as the 0–20 mA loop are "live."
If the test is successful:
If the test is unsuccessful:
If the cause of the fault has not been corrected, subsequent o i faults will
occur.
Latching relays are reset and LED turns green.
This function re-initializes the microprocessor, resets the operating
software, and initiates a hardware reset for both the sensor and the HART
interface. Latched relays are reset.
This function resets the HART data log history. To view the logs, go to
"Device Info Menu" and select "History Menu."
This menu performs various diagnostic and/or service functions.
CAUTION
Fire relay = Alarm
Fault relay = no fault
Current output is 20 mA
LED turns red
General log indicates "Man o i Pass"
Alarm log indicates "Fire Alarm"
Fire relay = No Alarm
Fault relay = Fault
Current output is 2 mA
LED turns yellow
Fault log indicates "Man o i Flt"
14
95-8637