Frame Assembly - 15' Fold Model - Landoll Tilloll 875 Series Operator's Manual

HINGE PIN
1/4 X 2 COTTER
PIN
1" FLAT
WASHER
5/8-11 HEX
LOCK NUT
FLAT WING SUPPORT
(FOR FOLD MODELS ONLY)
U-BOLT
545-106192-op

Frame Assembly - 15' Fold Model

IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.
1. Connect main frame and folding wing together using
hinge pin, 1" flat washers, and 1/4 x 2 cotter pins
(See Figure 3-2.)
2. Place frame assembly on stands approximately 36"
high.

Do not attempt to lift heavy parts (such as the
frame, disc gangs, rock shaft, and pull hitch)
manually. Use a hoist or a fork lift to move these
parts into position.
MAIN FRAME
Figure 3-2: Frame Assembly - 15' Fold Model
WARNING
ASSEMBLY INSTRUCTIONS
10" FOR PLACEMENT
1-8 HEX LOCK NUT
WING BRACKET
ROLLER WING
EXTENSION
1" FLAT WASHER
HINGE PIVOT BOLT
FOLDING WING
3-3