Figure 31 Operation Panel (Controller Enclosure For The Eternus Dx500 S5/Dx600 S5); Table 15 Status And Meaning Of Each Led (Operation Panel [Controller Enclosure For The Eternus Dx500 S5/Dx600 S5]) - Fujitsu ETERNUS DX S5 Series Operation Manual (Basic

A. Component Names
Controller Enclosure
LED name
CACHE
READY
*1: When the READY LED and the FAULT LED are both on at the same time, an error has occurred while the Unified configuration is
starting up.
●
ETERNUS DX500 S5/DX600 S5
An operation panel has LEDs, a Power switch, and setting change switches.
Figure 31
1
IDENTIFY LED
MAINTENANCE LED
READY LED
1
Power switch
This switch is used to turn on or off the ETERNUS DX.
2
MNT SW (maintenance switch)
This switch is used to switch the maintenance status on or off.
3
IP RST SW (IP reset switch)
This switch is used to initialize the LAN ports or to initialize the user information.
4
MST SW (CM Master Change switch)
This switch is used to change the Master CM.
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 15 Status and Meaning of Each LED (Operation Panel [Controller Enclosure for the ETERNUS DX500
S5/DX600 S5])
LED name
POWER
IDENTIFY
LED status
(green)
(green) (*1)
Operation Panel (Controller Enclosure for the ETERNUS DX500 S5/DX600 S5)
With a front cover
POWER LED
FAULT LED
CACHE LED
REMOTE LED
LED status
(green)
(blinks blue)
Meaning
There is data in the cache memory of the ETERNUS DX.
The ETERNUS DX is available for use.
Without a front cover
2 4
3
Meaning
Power is supplied to the controller enclosure.
The installation location of the controller is identified according to
the instruction that is issued from ETERNUS Web GUI or ETERNUS CLI.
106 Operation Guide (Basic)