Figure 26 Rear View Of A Controller Enclosure (When The Eternus Dx100 S5/Dx200 S5 Is Installed With Two Controllers) - Fujitsu ETERNUS DX S5 Series Operation Manual (Basic

A. Component Names
Controller Enclosure
Figure 26 Rear View of a Controller Enclosure (When the ETERNUS DX100 S5/DX200 S5 Is Installed with Two
Controllers)
1
2 3
CM#0
CA#0
PSU#0
1
Controller (CM#0, CM#1) (refer to
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3
Host interfaces (CA#0, CA#1) (refer to
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5
RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7
Power supply units (PSU#0, PSU#1) (refer to
1
4 5 3 6
CA#1
7
"■ Controllers" (page
"■ Host Interface" (page
2 3 4 5 3
CA#0 CA#1
PSU#1
7
109))
116))
"■ Power Supply Units" (page
101
6
CM#1
114))
Operation Guide (Basic)