Figure 28 Rear View Of A Controller Enclosure (Eternus Dx600 S5) - Fujitsu ETERNUS DX S5 Series Operation Manual (Basic

A. Component Names
Controller Enclosure
■
ETERNUS DX600 S5
Figure 28 Rear View of a Controller Enclosure (ETERNUS DX600 S5)
CPSU#0
8 9 9
1
Controllers (CM#0, CM#1)
(Refer to "■ Controllers" (page
2
Host interfaces (CA#0, CA#1, CA#2, CA#3)
(Refer to "■ Host Interface" (page
3
RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
4
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
5
FST (LAN) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
6
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
7
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
8
Power supply units (CPSU#0, CPSU#1)
(Refer to "■ Power Supply Units" (page
9
BUD (BUD#0, BUD#1)
(Refer to "■ BUD" (page
1 1 2
CA#2
CA#0
CA#2
CA#0
109).)
116).)
121).)
2
CA#3
CM#1
CA#1
CA#3
CM#0
CA#1
3 4 5 6 7
114).)
103
CPSU#1
8
Operation Guide (Basic)