USING THE MACHINE
MUX20JP021602
ground and the lower limit of the basket access ladder is less than 40 cm. If this is
not the case, move the ladder to the ground and carry out the stabilisation proce‐
dure from the basket.
• Select the motor speed as required and check the selection on the display.
Always perform stabilisation at slow speed.
• Press and hold the automatic stabilisation button 7 ʺPush buttons (p. 61)ʺ. If
the movements are selected with the machine not completely closed and aligned,
an
• error message will be shown on the display.
Fig. 92 Error close machine
• Stabilisation will be completed when the machine is in horizontal position
with tolerance of 1° and lifted at least 5 cm from the ground. Correct stabilisation
will be confirmed by the icon in position 5 on the display ʺFig. 39 Stabilized
machine(p. 56)ʺ. Always check the spirit level and make sure the slope is actually
less than 1°.
MANUAL STABILISER CONTROL
The manual control of the stabilisers must not be used to stabilise the machine but
only to correct its inclination in the event of stabilisation in difficult conditions. It
can also be used to lower or lift the stabilisers individually in order to increase the
stability of the machine, if it is necessary to transit areas with obstacles or steep
slopes.
100
Boom Lift Models X20JPLUS