JLG X20JPLUS Operator, Safety, Maintenance And Service Manual page 101

Table of Contents

MUX20JP021602

Always keep a distance from embankments or ditches that is equivalent to the

depth of such and observe the required safety distance from power lines.

Avoid any contact with objects or persons when lowering the stabilisers.

STABILISATION PROCEDURE

Before moving the stabilisers make sure that:

• All instructions provided in this chapter have been complied with

• The ground where the machine is stabilised is compact and can support the

weight of the machine and the maximum possible reaction force on one stabiliser;

When working the load on one individual stabiliser can increase greatly due to the

shifting of weight, especially if extension and/or rotation operations are performed.

THIS MUST ALSO BE CONSIDERED WHEN EXAMINING THE

GROUND.

• there are no obstacles on the stabilisation area and in the trajectory of each in‐

dividual stabiliser;

• the machine is completely closed and aligned, in the stabilisation position.

Fig. 91 Arrows feedback alignment

• Stabilisation can be carried out from the control position in the basket or on

the ground. If performing the operation from the ground, make sure there is com‐

plete visibility of the trajectory of each individual stabiliser before moving it and

check that at the end of the stabilisation procedure the distance between the

The complete closure and alignment is

displayed by the arrows on the machi‐

ne and the display of the icon in posi‐

tion 6 on the remote control ʺFig.

42 Aerial

aligned(p. 57)ʺ.

Boom Lift Models X20JPLUS

USING THE MACHINE

part

closed

and

Table of Contents