Battery Pack Maintenance Operating Specifications - JLG X20JPLUS Operator, Safety, Maintenance And Service Manual

Table of Contents

Advertisement

MUX20JP021602
12.18.BATTERY PACK MAINTENANCE OPERATING SPECIFICATIONS
The battery pack must be used and handled with care to ensure safe operation
and maximum machine performance. Any modifications made by unauthorised
personnel invalidate the warranty and  may cause damage to the  machine and
harm  to  people  and  things.  Only  qualified  personnel  are  authorised  to  handle
and access the battery pack. The battery pack is made up of just one module po‐
sitioned at the rear of the machine. In case of problems, only authorized person‐
nel are authorised to access the battery pack and replace it. Additional electronic
devices may have a negative influence on the correct operation of the electronic
components provided on the machine. For this reason it is absolutely forbidden
to use any devices on the vehicle that do not comply with directive 72/245/EEC
and its subsequent amendments (2005/49/EC, 2005/83/EC, 2006/28/EC). The con‐
structor accepts no liability for any damage due to failure to comply with this
warning.
NEVER OPEN THE BATTERY PACK
Opening and handling the battery pack is dangerous. Failure to ob‐
serve this warning automatically voids the warranty.
The battery pack works at peak performance and in safe conditions
with an ambient temperature between 0°C and 40°C. Using the bat‐
tery pack out of this temperature range may be dangerous.
Before working on the battery pack in any way read the paragraph
relating to the technical data of it ʺTechnical data (p. 19)ʺ.
The batteries and all electrical / electronic components that compose the battery
pack does not require maintenance. The only action required by the system is re‐
charging the batteries according to the frequency of use of the machine and in‐
struction  written  in  this  manual.  For  charging  the  battery  to  see  ʺCharging
Lithium batteries (p. 133)ʺ.
Avoid leaving the machine in sunny and badly ventilated places for long periods.
The battery pack is connected to the motor control via a fuse.
The fuse may be replaced only by qualified personnel. Always keep the battery
charged. Recharge the battery pack whenever considered necessary,
even if the battery has not completely run down. To check the battery level use
the  special indicator  provided. The  battery level depends  on many factors, for
this reason, to avoid incorrect reading of the indicator, always keep the batteries
charged. If the machine is not used for extended periods, recharge at least every
3 months.
Boom Lift Models X20JPLUS
MAINTENANCE
175

Advertisement

Table of Contents
loading

Table of Contents