Table of Contents
Advertisement
Refer to the following sheet for detailed information.
Parameter
Event Type
Channel
Enable
Sensitivity
Region
Period
Anti-dither
Normal out
Alarm Latch
Record Channel
Record Latch
Email
PTZ activation
Capture
Save
Refresh
There are three types: Motion detection/Video loss/Camera Masking.
Select channel name from the dropdown list.
Check to enable motion detection function.
There are six levels. The level 6 has the highest sensitivity.
- Region: after you select motion detection type, click this button to set motion
detection zone.
There are PAL 22X18/NTSC 22X15 zones.
Double right click mouse you can go to full-screen display mode.
Remember clicking OK button to save your motion detection zone setup.
- Motion detection function becomes activated in the specified periods.
- There are six periods in one day. Enable corresponding period.
- Select date or whole week.
- Click OK button, system goes back to motion detection interface.
Click save button to exit.
System only memorizes one event during the anti-dither period.
The value ranges from 0s to 15s.
- There is 1-channel alarm output.
- Corresponding to motion detection alarm output port.
- Enable alarm activation function.
You need to select alarm output port so that system can activate corresponding
alarm device when alarm occurs..
System can delay the alarm output for specified time after alarm end.
The value ranges from 10 seconds to 300 seconds.
System auto activates motion detection channel to record once alarm occurs
(works with motion detection function).
Note you need to go to chapter 7.2.3 Schedule to set motion detection record
period and go to chapter 7.3.3 Record to set current period as auto record.
System can delay the record for specified time after alarm ended.
The value ranges from 10 seconds to 300 seconds..
Send email when alarm occurs and ends.
Set PTZ movement when alarm occurs.
Such as go to preset x when there is an alarm.
Input capture channel number so that system can backup motion detection
snapshot file.
Click save button after complete setup for one channel, or complete the whole
setups and click save button.
Click this button to get device latest configuration information.
Function
47
Advertisement
Table of Contents
