Model Name "Name; Alarm(Safety Alarm For Low Voltage And Signal Strength ) - RadioLink RC4GS V3 Instruction Manual

RadioLink Electronic Limited
www.radiolink.com
(2) Press "Enter" button to get into CH3, CH4, or CH5 interface.
(3) Press "Enter" button, the adjusted value stops blinking, now the value has been set.

2.18 Model Name "NAME"

RC4GS V3 stores model memories for 30 models. Each model memory can
be named separately according to user's requirement.
Factory default name: MODEL1
(1) Long press "Exit" and "Enter" button simultaneously for one second to
enter the function menu of RC4GS V3. Press "Inc(+)" button at the bottom of
the screen to move the cursor to "18. NAME".
(2) Press "Enter" button to get into NAME function interface, the first
character of current name will blink, and the blinking character can be reset.
The common use characters appear at the bottom of the screen, use "Dec(-)"
or "Inc(+)" button to choose the character you desired.Press"Enter" button again, the next character of current
name will blink. Reset other characters of current name in same manner.
(3) After accomplishment of naming, all characters of current name will stop blinking, the new name will be
stored automatically.
(4) When ending setting,return to the initial screen by pressing"Exit"button twice.(the new setting model name
will appear on the initial screen)

2.19 ALARM(Safety alarm for low voltage and Signal strength )

Each model can independently set low voltage and RSSI value alarms, but the alarm functions of RATE and
temperature are not yet available.
When the voltage of the transmitter, receiver, vehicle battery, and RSSI signal strength are lower than the set
value, there will be a text displayed on the transmitter screen and a "didi" sound dual alarm prompt to remind
you.
You can set the value in the "ALARM" menu: Press "Exit" and "Enter"button at the same time to enter menu,
select the "19. ALARM" option, press "Enter"button to access the "ALARM" function interface. The transmitter
default alarm voltage is 7.2V, and it can be customized on 2-4S battery .The receiver default alarm voltage is
4.0V, and the vehicle battery default alarm voltage is 11.1V.
The default alarm voltage of single-chip battery is 3.7V. For example, if you use a 3S lithium battery for your
model, then the low voltage alarm value should be set to 11.1V (3.7V×3S). The setting method of transmitter
and receiver is the same.
30