Image Stabilization Timeout; Continue After Good Read - Newland NLS-HR3290 User Manual

Enter Setup

Image Stabilization Timeout

This parameter defines the amount of time that the scanner waits for the image to stabilize to a point that
it can be decoded with more accuracy. It is programmable in 1ms increments from 0ms to 1,600ms. The
default setting is 500ms.
Set the Image Stabilization Timeout to 1,500ms:
1. Scan the Enter Setup barcode.
2. Scan the Image Stabilization Timeout barcode.
3. Scan the numeric barcodes "1", "5", "0" and "0". (See the Digit Barcodes in
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Exit Setup barcode.

Continue after Good Read

Continue after Good Read: The scanner starts next decode session after good read.
Pause after Good Read: The scanner starts another round of illumination monitoring and image
stabilization after good read.
** Pause after Good Read
** Exit Setup
Image Stabilization Timeout
Appendix)
Continue after Good Read
32