Scan Mode; Manual Mode; Decode Session Timeout - Newland NLS-HR3290 User Manual

Scan Mode

Manual Mode

A trigger pull activates a decode session. The decode session continues until the barcode is decoded or
you release the trigger or decode session timeout expires.

Decode Session Timeout

This parameter sets the maximum time decode session continues during a scan attempt. It is
programmable in 1ms increments from 100ms to 3,600,000ms. The default setting is 3,000ms.
27
Decode Session Timeout
Set the Decode Session Timeout to 1,500ms:
1. Scan the Enter Setup barcode.
2. Scan the Decode Session Timeout barcode.
3. Scan the numeric barcodes "1", "5", "0" and "0". (See the Digit Barcodes in
Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Exit Setup barcode.
** Manual Mode
Enter Setup
** Exit Setup