Table of Contents
Advertisement
【Enter Setup】
Image Stabilization Timeout
The scanner waits for the image stabilization timeout to expire before activating a decode session every
time it detects a change in ambient illumination. The image stabilization timeout is programmable in 1ms
increments from 0ms to 1,600ms. The default setting is 500ms.
Set the Image Stabilization Timeout to 1,500ms:
1. Scan the Enter Setup barcode.
2. Scan the Image Stabilization Timeout barcode.
3. Scan the numeric barcodes "1", "5", "0" and "0". (See the Digit Barcodes in
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Exit Setup barcode.
Continue after Good Read
Continue after Good Read: The scanner starts next decode session after good read.
Pause after Good Read: The scanner starts another round of illumination monitoring and image
stabilization after good read.
**【Pause after Good Read】
**【Exit Setup】
【Image Stabilization Timeout】
Appendix)
【Continue after Good Read】
30
Advertisement
Table of Contents
