Table of Contents
Advertisement
Enter Setup
Image Stabilization Timeout
The scanner waits for the image stabilization timeout to expire before activating a decode session every
time it detects a change in ambient illumination. The image stabilization timeout is programmable in 1ms
increments from 0ms to 1,600ms. The default setting is 500ms. To learn how to program this parameter,
see Appendix 5.
Image Stabilization Timeout
Continue after Good Read
Continue after Good Read: The scanner starts next decode session after a good read.
Pause after Good Read: The scanner starts another round of illumination monitoring and image
stabilization after a good read.
** Pause after Good Read
Continue after Good Read
Timeout between Decodes
This parameter sets the timeout between decode sessions. When a decode session ends, next session
will not happen until the timeout between decodes expires. It is programmable in 1ms increments from 0ms
to 65,535ms. The default setting is 1,000ms. To learn how to program this parameter, see Appendix 5.
Timeout between Decodes
** Exit Setup
37
Advertisement
Table of Contents
