Continuous Mode
If the Continuous mode is enabled, the scanner automatically starts one decode session after another. To
suspend/resume barcode reading, simply press the trigger.
Decode Session Timeout
This parameter sets the maximum time decode session continues during a scan attempt. It is
programmable in 1ms increments from 100ms to 3,600,000ms. The default setting is 3,000ms.
35
Decode Session Timeout
Set the Decode Session Timeout to 1,500ms:
1. Scan the Enter Setup barcode.
2. Scan the Decode Session Timeout barcode.
3. Scan the numeric barcodes "1", "5", "0" and "0". (See the Digit Barcodes in
Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Exit Setup barcode.
Continuous Mode
Enter Setup
** Exit Setup