Sense Mode
The scanner waits for the image stabilization timeout to expire before activating a decode session every
time it detects a change in ambient illumination. Decode session continues until the barcode is decoded
or the decode session timeout expires.
In the Sense mode, a trigger pull can also activate a decode session. The decode session continues until
the barcode is decoded or the trigger is released. When the session ends, the scanner continues to
monitor ambient illumination.
Decode Session Timeout
This parameter sets the maximum time decode session continues during a scan attempt. It is
programmable in 1ms increments from 100ms to 3,600,000ms. The default setting is 3,000ms.
31
Decode Session Timeout
Set the Decode Session Timeout to 1,500ms:
1. Scan the Enter Setup barcode.
2. Scan the Decode Session Timeout barcode.
3. Scan the numeric barcodes "1", "5", "0" and "0". (See the Digit Barcodes in
Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Exit Setup barcode.
Sense Mode
Enter Setup
** Exit Setup