Quick" Pushbuttons - Crestron Isys TPS-3100L Operation Manual

6.4" Lectern/Wall Mounted Touchpanel
30 • 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys® TPS-3100L
1. Use the Browse button to locate the desired WAV files. It should
appear in the field adjacent to the Browse button.
2. If necessary, select the Play button to verify that the file in the browse
field is the desired file.
3. Select the Add button to transfer the WAV file to the Sound List table
located below the browse field. The audio parameters of the file also
appear to the right of the table.
4. Repeat steps 1 through 3 for each desired WAV file.
NOTE: To remove a WAV file from the Sound List table, highlight the file and
click on the Remove button.
5. Select a WAV file in the Sound List table and click Properties to open
the "Sound Properties" window. Assign a join number either
automatically with the Auto button or by scrolling down to the desired
number. Select Description to enter comments about the WAV file and
click OK when done.
NOTE: The assigned WAV file will play once when the feedback join goes high.
6. Repeat for each WAV file.

"Quick" Pushbuttons

The touchpanel includes five "quick" pushbuttons, located on the side of the LCD
screen. These buttons can be programmed to access any frequently used command.
Each button has a permanently fixed digital join number. The sequence of digital
join numbers is (top to bottom) 1 through 5. Refer to the following diagram that
illustrates the buttons and their assigned join numbers.
Pushbutton Layout and Join Number Assignment
NOTE: A VT Pro-e sample project, TPS-3100L.VTP, is available from the
VT Pro-e section of the Crestron FTP site (ftp://ftp.crestron.com/VTPro-E/). This
project provides guides for panel designers so that they can line up objects with the
five "quick" pushbuttons that flank the LCD display. New users are required to
register in order to obtain access to the FTP site.
®
Crestron Isys TPS-3100L
1
2
3
4
5
Operations Guide – DOC. 6291