Crestron Isys TPS-3100L Operation Manual page 39

6.4 inch lectern/wall mounted touchpanel

Hide thumbs Also See for Isys TPS-3100L:

Table of Contents

Crestron Isys

TPS-3100L

Operations Guide – DOC. 6291

6.4" Lectern/Wall Mounted Touchpanel

Setup | Communications Settings Command

3. Select RS-232 as the connection type. Verify that an available COM port

(COM 1 is shown after this step) is selected, and that all communication

parameters and necessary options from the "Port Settings" window are

selected as shown after this step. Click the OK button to save the settings

and close the window.

"Port Settings" Window

NOTE: The parameters shown in the previous illustration are the port settings for a

2-Series control system. Consult the Operations Guide for the control system being

used for exact parameter selection. Default communication parameters for the

touchpanel are 115200, 8 bit, parity none, stop bit 1, XON/XOFF off, RTS/CTS off.

NOTE: If connecting to the touchpanel through a control system, the baud rate may

need to be set to 38400 baud (Cresnet speed) for a successful transfer.

6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys® TPS-3100L • 35

Table of Contents