Crestron Isys TPS-3100L Operation Manual page 42

6.4" Lectern/Wall Mounted Touchpanel
38 • 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys® TPS-3100L
File Transfer | Send Touchpanel Command
3. As shown after this step, select the Net ID of the TPS-3100L touchpanel
and then click OK. The "Touch Panel Transfer" window appears (refer to
the subsequent graphic).
"Select Network ID" Window
NOTE: If problems occur when transferring any Cresnet file (touchpanel
project/firmware), lower the port speed baud rate to 38400 to match the Cresnet bus
speed when transferring through a control system.
"Touch Panel Transfer" Window
Additional choices include Do not send graphic files and Do not send sound files.
These are often very large files that take a long time to load.
4. Click Browse. The "Open" window appears as shown in the following
illustration.
Crestron Isys
Check Send Direct to Wired Touchpanel if
connected via RS-232 directly to touchpanel.
Each time a project is selected using
the Browse command, that project is
added to the File Name drop-down
list. This makes it convenient to
recall projects without need to
browse to a directory. To delete the
list click Clear History.
All Files in Project: sends the entire
project.
Only Changed Files: sends only the
files that are different from those
that are currently stored in the panel.
Note that if any pages in the panel
are not present in the project, those
pages will be deleted from the panel.
Operations Guide – DOC. 6291
®
TPS-3100L