Crestron Isys TPS-3100L Operation Manual page 21

®
Crestron Isys TPS-3100L
Operations Guide – DOC. 6291
6.4" Lectern/Wall Mounted Touchpanel
NOTE: When sending balanced audio from a CNX-BIPAD8 or CNX-PVID device,
only the Positive (+) and Negative (-) wires are to be connected to the touchpanel.
Do not connect the Shield (S) wires.
AUDIO Pinouts-Unbalanced
PIN # DESIGNATION
1 S
2 R+
3 R-
4 L+
5 L-
6 S
NOTE: Using two jumpers, connect R Shield to R - and L Shield to L - respectively
at the TPS-3100L Audio Input connector. Refer to the following diagram.
Wiring for Unbalanced Audio
+ - + -
S R R L L S
+ +
Jumpers
NTSC/PAL INPUT
This port provides unbalanced composite and S-video input (using a 2-position mini-
terminal block connectors) or balanced video input (using a 6-position mini-terminal
block connector) for video signals. Both sets of inputs support both NTSC and PAL
formats. Balanced video format is typically used when distributing video via CAT 5
(i.e., from a Crestron CNX-PVID8x3 or 8x4). Unbalanced video is typically used
when distributing video via coaxial cable.
NOTE: Cable runs for balanced video should not exceed 500 feet (152.4 meters)
and cable runs for unbalanced video should not exceed 100 feet (30.5 meters). For
distances greater than these specified lengths use a distribution amplifier.
6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys® TPS-3100L • 17
DESCRIPTION
Ground
Right Input (Positive)
Right Ground
Left Input (Positive)
Left Input Ground
Ground