Setup; Applying Power; Docking The Stx-1700Cw - Crestron STX-1700CW Operation Manual

Wall Mount 2-Way RF Compact Color Touchpanel

Setup

6 • Wall Mount 2-Way RF Compact Color Touchpanel: STX-1700CW
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. The equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and transceiver.
■ Connect the equipment into an outlet on a circuit different from that to which the
transceiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.

Applying Power

The touchpanel can be powered via the ST-BTPN, while docked in the DA-1700CW,
or via the external power pack. Each of these items has its own guide which details
proper usage. Refer to the table below for the required document number.
STX-1700CW Power Source Options
POWER SOURCE OPTION
Battery Pack
Docking Assembly
Domestic External Power Pack or
International External Power Pack
*
The latest revision may have a revision letter after the document number (i.e., 6088A).

Docking the STX-1700CW

To dock the STX-1700CW, refer to the procedure below.
NOTE: Do not dock the STX-1700CW into the DA-1700CW without the ST-BTPN
being installed in the touchpanel. Operating power for the DA-1700CW is supplied
through the electrical contacts of the ST-BTPN. If the ST-BTPN is not installed, the
DA-1700CW will not electrically undock the touchpanel, it would have to be
manually undocked (refer to "Manually Undocking of Touchpanel" on page 8).
1. Refer to the following diagram. Insert the bottom edge of touchpanel
docking plate (located on the rear of the touchpanel) into DA-1700CW
directly behind the front panel.
Crestron STX-1700CW
DOCUMENT
MODEL
NUMBER *
ST-BTPN 6088
DA-1700CW 6104
PW-1215 5762
PWI-1215 5763
Operations Guide – DOC. 6228A