Table of Contents
Advertisement
Crestron QM-FTSC
A control system source file has
the extension .smw. A compiled
SIMPL Windows file has the
extension .spz for a 2-Series
control system.
Operations & Installation Guide – DOC. 6269
Uploading a SIMPL Windows Program
The SIMPL Windows file can be uploaded to the control system using SIMPL
Windows or via the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the "Open" window, navigate to the SIMPL
Window file (.smw), and click Open.
3. Select Project | Transfer Program.
Upload via Crestron Viewport
1. Verify that the procedure for "Communication Settings" that begins on
page 34 has been performed.
2. As shown after this step, select File Transfer | Send Program
(alternatively, press Alt+P) from the Viewport menu bar.
File Transfer | Send Program Command
3. The "Send Program" window appears, as shown on the next page.
Click Browse, locate the compiled file (.spz for QM-RMCRX) and
click Open. This will display the program's header information and
enable one or both of the What to Send check boxes. If the program
does not contain any SIMPL+ modules, only the SIMPL Program
check box will be enabled. If it does contain SIMPL+ modules, then the
SIMPL+ Program(s) check box will also be enabled. Select one or both
check boxes and then click Send Program to begin the transfer.
NOTE: Refer to the respective Operations Guide for the control system for
details about the other fields shown on the "Send Program" window.
FlipTop Storage Center
FlipTop Storage Center: QM-FTSC • 37
Advertisement
Table of Contents
