Table of Contents
Advertisement
Crestron QM-FTSC
NET
NET
24 Y Z G
24 Y Z G
1
8
125V – 50/60Hz 10A
Operations & Installation Guide – DOC. 6269
NET (x2)
These two 4-pin terminal block connectors, located on the right side of the QM-
FTSC, are for connection to the Cresnet network. One connector is used to connect
to the Cresnet network while the second connector can be used to connect another
Cresnet device. Cresnet power to the QM-FTSC is supplied through either of these
connectors. For more information, refer to "Network Wiring" on page 11.
QM
This eight-pin RJ-45 transport port, located on the right side of the QM-FTSC,
allows connection of the QuickMedia cable. It carries audio, video, and microphone
signals over CAT5E cable to a QuickMedia receiver or switcher. For more
information on QuickMedia refer to page 2.
QM Pin Assignments
PIN
WIRE COLORS (568B)
1
WHITE/ORANGE
2
ORANGE
3
WHITE/GREEN
4
5
WHITE/BLUE
6
GREEN
7
WHITE/BROWN
8
BROWN
NOTE: When transmitting S-video, luminance uses the green video pathway,
and chrominance uses the red video pathway. When transmitting composite
video, the signal is carried on the blue video pathway.
NOTE: Always use Crescat-QM cable, or a good quality CAT5E/CAT6 cable
to make QuickMedia connections.
NOTE: When using Crescat-QM Siamese cable, four additional wires are
included for making Cresnet connections.
AC Power
Connect the six-foot (183 cm) grounded AC line cord to supply AC power to
the outlet on the topside of the QM-FTSC.
FlipTop Storage Center
BLUE
FlipTop Storage Center: QM-FTSC • 9
DESCRIPTION
- RGB Red
+ RGB Red
- RGB Green
+ Digital Audio
- Digital Audio
+ RGB Green
- RGB Blue
+ RGB Blue
Advertisement
Table of Contents
