Industry Compliance - Crestron QM-FTSC Operation And Installation Manual

FlipTop Storage Center Crestron QM-FTSC
Indicators
PWR (Power)
This LED illuminates when 24 volts DC is supplied to the QM-FTSC from
Cresnet.
NET
This LED illuminates when communication between the control system and the
QM-FTSC is established (the unit is polled on the network). Illumination
indicates that the SIMPL Windows program currently loaded has a network
device defined at the same Net ID as the QM-FTSC. The LED flashes when
communication with the processor occurs.
COMP
The COMP LED illuminates when an RGB signal from the computer port is
detected.
VIDEO
This LED illuminates when the presence of a composite video signal is detected
by the QM-FTSC.
S-VID
This LED illuminates when the presence of an S-video signal is detected by the
QM-FTSC.
MIC PWR
Illuminates when phantom power is applied to the microphone inputs.
SETUP LED and Pushbutton
The QM-FTSC is Touch-Settable ID-ready. A SETUP pushbutton is concealed
behind a faceplate during normal use. The SETUP pushbutton and its associated
LED are used for setting a units network ID during the initial configuration of a
Cresnet system or when the device is being added/replaced. Refer to "Method B
(Touch Settable ID)" on page 13 for detailed information.

Industry Compliance

As of the date of manufacture, the QM-FTSC has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling (N11785).
NOTE: This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
10 • FlipTop Storage Center: QM-FTSC
Operations & Installation Guide - DOC. 6269