Seco SBC-C41-pITX User Manual page 58

4.4.2 Uncore Configuration submenu
Menu Item
GOP Brightness Level
DDI0 DDC Pull Type
DDI1 DDC Pull Type
Integrated Graphics Device
Primary Display
HG Delay After Power Enable
HG Delay After Hold Reset
RC6 (Render Standby)
GTT Size
Aperture Size
DVMT Pre-Allocated
DVMT Total Gfx Mem
Cd Clock Frequency
GT PM Support
PAVP
SBC-C41-pITX
SBC-C41-pITX User Manual - Rev. First Edition: 1.0 - Last Edition: 1.1 - Author: A.R./S.B. - Reviewed by M.B. Copyright © 2021 SECO S.p.A.
Options Description
20/40/60/80/100/120/1
40/160/180/200/220/2 Set Graphics Output Protocol (GOP) Brightness Level; value ranges from 0 to 255
40/255
Pull Up 1K
Pull Up 2K Sets DDI #0 Pull-up values
Pull Up 5K
Pull Up 1K
Pull Up 2K
Sets DDI #1 Pull-up values
Pull Up 5K
Enable the Integrated Graphics Device (IGD) when selected as the Primary Video Adaptor, or always
Enabled / Disabled
disable it.
Select which of IGD / PCIe /HG graphics device should be the Primary Display
IGD / PCIe / HG
[0..1000] Delay in milliseconds after power enable
[0..1000] Delay in milliseconds after hold reset
Permits to enable the render standby features, which allows the on-board graphics entering in standby
Enabled / Disabled
mode to decrease power consumption
2 MB / 4 MB / 8 MB Select the GTT (Graphics Translation Table) Size
256 MB Use this item to set the total size of Memory that must be left to the GFX Engine
64M / 96M / 128M /
160M / 192M / 224M /
256M / 288M / 320M /
Select DVMT5.0 Pre-Allocated (Fixed) Graphics Memory size used by the Internal Graphic Device
352M / 384M / 416M /
448M / 480M / 512M
128M / 256M / MAX Select the size of DVMT (Dynamic Video Memory) 5.0 that the Internal Graphics Device will use
144 MHz / 288 MHz /
384 MHz / 576 MHz / Select the highest CD Clock frequency supported by the platform
624 MHz
Enabled / Disabled Enable / Disable GT Power Management Support
Enabled / Disabled Enable / Disable Protected Audio Video Playback (PAVP)
58