Seco SBC-C41-pITX User Manual page 53

4.3.17 Embedded Controller submenu
Menu Item
Power Fail Resume Type
No C-MOS battery handling
OUT 80 redirection port
Hardware Monitor
Reset Causes Handling
Super IO Configuration
Internal FAN Settings
Watchdog Configuration
GPIO Configurations
4.3.17.1 Monitor hardware parameters and settings submenu
This submenu contains Monitor hardware parameters and settings information:
-
Up time
-
CPU FAN speed
-
RAM Temperature
-
VCGI_RUN
-
VNN_RUN
-
MEM_VDD_SUS
-
1.24V_ALW
-
1.8V_ALW
-
1.05V_RUN
SBC-C41-pITX
SBC-C41-pITX User Manual - Rev. First Edition: 1.0 - Last Edition: 1.1 - Author: A.R./S.B. - Reviewed by M.B. Copyright © 2021 SECO S.p.A.
Options Description
Always ON Specify what state to go to when power is re-applied after a power failure (G3 state). If Batteryless
Always Off Operation, the chipset always powers on after a power failure: Always Off Resume Type or Laste State
Last State when Last State was OFF will therefore require an immediate shutdown
In systems with no C-MOS battery, the chipset always powers on after a power failure: Always OFF
Disabled / Enabled
Resume Type or Last State when Last State was OFF will therefore require an immediate shutdown
Selects which Embedded C
None / 1 / 2 / 1+2
1+2
See Submenu Monitor hardware parameters and settings
See Submenu Reset Causes Handling
See Submenu Super IO Configuration
See Submenu Internal FAN Settings
See Submenu Configure the Watchdog Timer
See Submenu GPIO Configurations
UART(s) will receive OUT80 Post Codes: it can be none, 1 , 2 or
53