Seco SBC-C41-pITX User Manual page 45

Table of Contents

Advertisement

4.3.4.1 Console Redirection Settings submenu
Menu Item
Terminal Type
Bits per second
Data bits
Parity
Stop bits
Flow Control
VT-UTF8 Combo Key Support
Recorder Mode
Resolution 100x31
Putty Keypad
SBC-C41-pITX
SBC-C41-pITX User Manual - Rev. First Edition: 1.0 - Last Edition: 1.1 - Author: A.R./S.B. - Reviewed by M.B. Copyright © 2021 SECO S.p.A.
Options
Description
Emulation:
VT100
ANSI: Extended ASCII Char set.
VT100+
VT100: ASCII Char set.
VT-UTF8
VT100+: extends VT100 to support colour, function keys, etc.
ANSI
VT-UTF8: uses UTF8 encoding to map Unicode chars onto 1 or more bytes
9600 / 19200 / 38400 /
Select Serial port Transmission Speed. The speed must be matched on the other side. Long or noisy lines
57600 / 115200
may require lower speeds.
7 / 8
Set Console Redirection data bits
None
A parity bit can be sent with the data bits to detect some transmission errors.
Even
Even: parity bit is 0 if the number of 1s in the data bits is even.
Odd
Odd: parity bit is 0 if the number of 1s in the data bits is odd.
Mark
Mark: parity bit is always 1.
Space
Space: parity bit is always 0. Mark and Space do not allow for error detection
Stop bits indicate the end of a serial data packet. (A start bit indicates the beginning). The standard setting
1 / 2
is 1 stop bit. Communication with slow devices may require more than 1 stop bit
Flow Control can prevent data loss from buffer overflow. When sending data, if the receiving buffers are full,
None
a 'stop' signal can be sent to stop the data flow. Once the buffers are empty, a 'start' signal can be sent to
Hardware RTS/CTS
re-start the flow. Hardware flow control uses RTS# / CTS# lines to send the start / stop signals.
Enabled / Disabled
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals
Enabled / Disabled
When this mode is enabled, only text will be sent. This is to capture Terminal data.
Enabled / Disabled
Enables or disables extended terminal resolution
VT100 / Intel Linux /
XTERMR6 / SCO / ESCN
Select FunctionKey and KeyPad on Putty
/VT400
45

Advertisement

Table of Contents
loading

Table of Contents