GRAPHTEC Cutting PRO FC2230 Series Service Manual page 31

3.1.2 Running a Cutting Test
Function selection
TEST
Warning : The pen starts moving as soon as the SELF TEST mode is selected by pressing the
2 key (YES) .
To avoid injury to yourself and damage to the plotter, keep your hands, face, and other
obstacles out of the vicinity of the pen carriage and Y bar.
3.1.3 Listing the Cutting Conditions
Function selection
CONDITION
Warning : The pen starts moving as soon as the CONDITION FUNCTION is selected by pressing
the 2 key .
To avoid injury to yourself and damage to the plotter, keep your hands, face, and other
obstacles out of the vicinity of the pen carriage and Y bar.
3.1.4 Setting the Cutting Origin
Function selection
ORIGIN
3.1.5 Using the COPY Function
Function selection
COPY
Caution : ・While a copy operation is in process, do not send new data to the plotter.
・ Data which exceeds 1 Mbyte cannot be stored in the buffer, and therefore cannot
be copied.
・ Be sure to specify the position of the original cut as close to the origin point as
possible. The distance between the original cut and the first copy is the same as the
distance between the original cut and the origin.
・ If there is an interval of 10 seconds or greater when data is sent, the previous data
is cleared.
・ Make sure that cutting does not extend past the edges of the film and onto the
panel itself.
FC2230-UM251-01-1600
Submenus
1 TEST1
2 CUTTING PRO
3 TEST2
Submenus
1
2
3
4
Submenus
Submenus
Function Description
one triangle inside a square
CUTTING PRO characters
three triangles within squares
Function Description
FORCE
SPEED
OFFSET
QUALITY
Function Description
Setting the Cutting Origin
Function Description
Using the COPY Function
3-2