Fan Preparation 1 - Casablanca Nouvelle Owner's Manual

Step 4. Attach the canopy to the cross bar with
three (3) of the 8-32 X 4 1
/
8
#8 lock washers, hand tighten until snug against
the ceiling. On sloped ceilings, align the canopy
hatch opening toward the top or peak of the
room. Your Casablanca fan may be installed on
a vaulted or cathedral ceiling in the same man-
ner as described for a flat ceiling.
®
The Hang-Tru mounting system makes it pos-
sible to hang your fan on ceilings sloped up to
a 32 angle.
MOTOR COVER
Note: For the next 5 prepara-
tion steps it is convenient to
leave the fan body in the lower
carton styrofoam as it provides
a stable work-top.
Preparation Step A. Remove the
motor shield from the top of the
motor, note the caution message
and read the instructions care-
fully.
Preparation Step B. Slide the motor cover onto
the Perma • Lock™ downrod assembly as shown.
TIP: Use masking tape to temporarily hold
the motor cover to the downrod ball; this
will ease downrod installation.
CANOPY INSTALLATION
canopy screws and
FAN PREPARATION - HARDWARE
DOWNROD &
BALL ASSEMBLY

FAN PREPARATION 1

DANGER
IT IS IMPERITIVE THAT THE LOCKSCREW
BE SET TIGHTLY AGAINST THE DOWNROD
THREADS AFTER FAN IS ASSEMBLED
FAILURE TO DO SO WILL CAUSE FAN TO FALL
DO NOT OIL SEALED BEARINGS!
INSTALLER INSTALLER
GIVE THIS TAG TO THE CONFIRM LOCKSCREW
CONSUMER AFTER IS PROPERLY TIGHTENED
INSTALLATION COMPLETE
P/N 1942640 SRB4/96
TIGHTEN TIGHTEN
LOCKSCREW LOCKSCREW
CAUTION
DAMP LOCATION RATED FANS
REQUIRE A GROUND FAULT INTERRUPTER (GFI)
USE A WEATHER PROOF OUTLET BOX
PROPERLY CONNECT GROUND WIRES
USE ONLY UNDER A WEATHER
PROOF STRUCTURE
MOTOR
SHIELD
FAN PREPARATION 2
N
OUVELLE
CANOPY
HATCH
OPENING
CANOPY
LOCK
WASHER
ALLEN SET SCREW
PHILLIPS
1 ⁄
COUNTERSUNK SCREW
4
(PRE-INSTALLED)
8-32 X 9
/
16
MOTOR
WIRES
DOWNROD
&
BALL ASSEMBLY
MOTOR
COVER
™
CANOPY
CANOPY
SCREW
3mm
-20 x 1 ⁄ " ALLEN WRENCH
4
Note: Write down the
Serial Number and
the model number for
future reference.
GROUND
WIRE
FAN
BODY
5