Table of Contents
Advertisement
BLADE HARDWARE (not to scale)
Blades (4)
(not included)
Attach Blade Irons
Step 4a. Using the blade screws in Pack C and the provided
screwdriver, attach the blades to the blade holders by
aligning the screw holes of the blade iron with the holes
in the blade. Attach the blade iron using the four blade
screws provided for each blade, as shown. Tighten securely
by hand only.
Blade Installation:
Step 5. Using the blade screws in Pack D and the provided
screwdriver, attach the blade assembly to the motor as
shown. Tighten screws by hand only.
TIP: For balancing purposes, loosely install all 4 blades
to the motor before tightening the blade screws securely.
CAUTION:
Blade screws must be tightened securely before
operating the fan.
PERMA•LOCK™ HARDWARE (not to scale)
Uplight Lightbulbs S-11 25-watts (4)
IMPORTANT SAFETY INFORMATION:
Before starting the installation of your ceiling fan,
install the threaded downrod into the motor
coupling and lock the assembly.
Prepare for fan installation as follows:
Step 6a. Remove the paper shield from the motor.
Step 6b. Route the wires through the Perma•Lock™
downrod and ball assembly.
6
BLADE INSTALLATION
Blade Irons (4)
FAN PREPARATION
Allen Wrench
TIP: The downrod has a tapered thread that is designed
to lock completely when installed correctly.
Pack C:
Blade Screws and
Washers (17)
Blade Iron Screws (9)
3" Perma•Lock™ Downrod
and Ball Assembly
Pack D:
Advertisement
Table of Contents
