Fan Preparation - Casablanca Antion C39G199L Owner's Manual

MOUNTING BRACKET INSTALLATION (CONT.)
Step_1._ Align the slotted holes in the ceiling plate
with the pilot holes you drilled in the wood support
structure. For proper alignment use slotted holes
directly across from each other.
Note:_The isolators should be flush against the
ceiling.
Step_2._ Place a flat washer on each of the two
3" wood screws and pass the screws through the
slotted holes in the ceiling plate into the pilot holes
you drilled.
Step_3._ Tighten the screws into the 9/64" pilot
holes; do not use lubricants on the screws. Do not
over tighten.
PREPARATION HARDWARE
SET SCREW
(pre-installed)
Hanging Adapter
Cover
Canopy

FAN PREPARATION

Prepare for fan installation as follows:
Step_1._ Remove the paper shield from the motor
as shown in Figure #1.
Step_2._ Loosen the set screw making sure that
end of the Set Screw can not be seen within the
motor coupling as shown in (Figure #2). If so, you
will need to unscrew the Set Screw so that the tip
of the Set Screw does not remain in the path of the
downrod.
CAUTION: Failure to fully lock in the
downrod before securely tightening the
set screw may cause the fan to separate
from the downrod and fall during normal
operation.
8
Joist
Ceiling Fan
Approved
Washer
Wiring Box
Wood
Screw
Note: On sloped ceilings, align
the canopy opening toward
the top or peak of the room.
Perma•Lock™ Downrod
and Ball Assembly
Trim Ring
PAPER MOTOR
SHIELD
FIGURE_1.
Set Screw
FIGURE_2.
Step_3._ Slide the Canopy, Trim Ring, Hanging
Adapter Cover on to the pole, then route the
wires through the 4.5" Perma•Lock downrod and
ball assembly as shown in Figure #3. Insert the
downrod into the motor coupling and turn it
clockwise until it stops turning, ensuring that the
pole has bottomed out.
Tip: The downrod has a tapered thread that
is designed to lock completely when installed
correctly.
Step_4._ Tighten the set screw as shown in Figure
#4 to ensure safe operation of your fan. If it is tight
enough, you should not be able to turn the downrod
counterclockwise with your hands. If in doubt, tighten
the set screw with until you cannot turn it any further.
a
™
ntion
MOTOR WIRES
(LEAVE AT LEAST
6" LONG)
PERMA•LOCK™
DOWNROD AND
BALL ASSEMBLY
Canopy
Trim Ring
MOTOR
Hanging
COUPLING
Adapter Cover
SET SCREW
FIGURE_3.
CAUTION: Failure to fully lock in the
downrod before securely tightening the
Set Screw may cause the fan to separate
from the downrod and fall during normal
operation.
Set Screw
FIGURE_4.
9