Table of Contents
Advertisement
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping
cartons and check them against the parts listed in instructions.
Before discarding packaging material, be certain that all parts have been removed.
Carton Contents
The fan carton contains the fan body, warranty card, owner's
manual, and all the parts necessary (except blades) to assemble
and install your Casablanca ceiling fan. These parts are shown
at the start of each installation section. Before you start, go
through this Owner's Manual and confirm that you have all the
parts shown in each section.
CROSSBAR
MOUNTING
BRACKET
CANOPY
HATCH
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked accept-
able for ceiling fan support.
INSTALLATION INSTRUCTIONS
GETTING STARTED
CEILING HARDWARE
WIRE NUT (4)
SUPPORT INSTALLATION PARTS
CANOPY
ADAPTOR
PLATE
CANOPY HARDWARE
CANOPY
GETTING STARTED - CONTINUED
N
OUVELLE
Be sure to use only genuine Casablanca blades. The blade
shrink wrap holds 5 blades of matched weight. If more than
one fan is being installed, be sure not to mix blade sets.
CAUTION: When removing the shrink wrap, be careful not
to scratch the blades.
PHILLIPS
SCREWDRIVER
SCREW 2
LAG SCREW
3
/
" #7 X 5" (1)
8
CANOPY SCREW
8-32 X 4
CANOPY LOCK WASHER
#8 (4)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is a UL
listed ceiling box for ceiling fan applications. If it is not, a
new box must be installed.
™
ADDITIONAL HARDWARE
SCREW 1 (2)
FLAT
WASHER
(2)
1
(2)
/
4
LARGE
FLAT WASHER
3
/
" (1)
8
(4)
1
/
"
8
3
Advertisement
Table of Contents
