Preparation Instructions; Fan Preparation; Ceiling Hardware; Getting Started - Casablanca Ceiling Fan Owner's Manual

Hide thumbs Also See for Ceiling Fan:

Installation manual (22 pages)

Installation and operation manual (21 pages)

Installation manual (20 pages)

Table Of Contents

Table of Contents

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them

against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.

(MOTOR COUPLING)

IMPORTANT SAFETY INFORMATION!

BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN,

INSTALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND

Prepare for fan installation as follows:

Step A. Route the wires from the motor through the

Perma • Lock™ downrod and ball assembly, keeping the wires

to one side of the cross pin.

NOTE: The downrod has a tapered thread

that is designed to lock completely when

correctly installed.

Step B. Thread the downrod into the motor coupling until it

stops turning, this will take at least four and a half full turns.

Step C. Securely tighten the locking bolt to ensure safe op-

eration of your fan.

CAUTION: Failure to fully lock in the down-

rod before securely tightening the locking

bolt may cause the fan to fall during nor-

mal operation!

CROSSBAR

MOUNTING

BRACKET

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where you wish

to place your Casablanca fan, an approved ceiling fixture

outlet box must be installed and wired.

Warning: To reduce the risk of fire, electrical shock,

or personal injury, mount to outlet box marked

acceptable for ceiling fan support using the mount-

ing hardware provided with the outlet box.